Before you order
Measuring and photographing your old bath
From your photos we determine the bath type and whether extra work is needed. We need three specific photos and three measurements.
The whole bath from the side
Step back a couple of metres and photograph the bath in full from the side, so the entire length is visible. A close-up of one corner is not enough.
From above and the sewer
Take a second photo looking straight down into the bath, and a third of the sewer connection and drain underneath it.
Measure length, width and depth
Measure the length and width from outer edge to outer edge, and the depth from the bottom to the top edge. An ordinary tape measure is fine.
FAQ
Frequently asked questions
If you cannot find your answer, call or write — we are happy to help.
How much does bath installation cost?
Bath installation costs 370€. That includes the new bath liner, all working materials, and transport within Tallinn. Additional services (such as a front panel or drain replacement) are always agreed in advance.
I live outside Tallinn. How much is transport?
We install baths throughout Estonia. Transport is free in Tallinn and the surrounding area; elsewhere a transport fee applies. Just ask us for the exact transport price — we will get straight back to you.
How quickly do you reply, and when can the bath be fitted?
Once you send the measurements and photos we reply quickly, confirm the bath type and agree on a suitable installation time. In most cases we can fit the bath within a few days.
How long after fitting can the bath be used?
After fitting, the technician fills the bath with water and it must stand for 12 hours while the adhesive cures. After that the bath is ready to use.
Which photos do you need?
We need three photos in order to identify the bath type and any extra work:
- the whole bath from the side, taken a couple of metres back so the full length is visible;
- the bath seen from directly above;
- the sewer connection and drain underneath the bath.
A more detailed guide, including measuring, is at the top of this page.
Installation creates some waste. Do I have to dispose of it?
Yes, fitting a new bath produces a small bag of waste, and disposing of it is the customer’s responsibility.
What extra work might come up before or during installation?
Depending on the condition of the old bath, the following may be needed:
- cutting the bath front wall and fitting a hatch for sewer access;
- replacing the sewer pipe or the drain;
- cleaning the tiles to prepare the surface.
Does a new bath fit every old bath?
Bath-in-bath is made for cast-iron baths — our liners are moulded for them. We do not fit a liner inside a steel bath.
If your bath is steel, we can replace it entirely: we remove and dispose of the old bath and install a new plastic bath together with a new drain and a front panel. That service costs 950€.
This is exactly why we ask for measurements and photos — from those we tell you which of the two suits your bathroom.
Ready to order your new bath?
Send us the measurements and three photos — we reply quickly and book your installation.